一、準備工作：

1、 Preparation work:

　　1、檢查鋼板表面是否有污染物，有的話清洗干凈；

1. Check if there are any pollutants on the surface of the steel plate, and if so, clean it thoroughly;

　　2、檢查是否有損壞的地方，有的話需要修理；

2. Check if there are any damaged areas, and if so, repair is needed;

　　3、檢查折彎邊緣是否有損壞，有的話需要進行補強；

3. Check if there is any damage to the bent edge, and if so, reinforce it;

　　4、確定包口位置，把定位線劃好；

4. Determine the position of the package opening and mark the positioning line;

　　二、施工步驟：

2、 Construction steps:

　　1、用折彎?rùn)C(jī)把鋼板折彎，把折彎后的鋼板放在模具上，調整好鋼板位置；

1. Use a bending machine to bend the steel plate, place the bent steel plate on the mold, and adjust the position of the steel plate;

　　2、用鉆床鉆孔，鉆孔的位置要與定位線對齊；

2. Drill holes using a drilling machine, aligning the drilling position with the positioning line;

　　3、用焊槍焊接，焊接的位置要與孔的位置對齊，焊接完成后檢查焊縫是否滿足要求；

3. Weld with a welding gun, aligning the welding position with the hole position. After welding is completed, check whether the weld meets the requirements;

　　4、用角磨機將包口邊緣磨平，確保包口邊緣的平整度；

4. Use an angle grinder to smooth the edge of the packaging to ensure its flatness;

　　5、用打磨機打磨表面，確保表面光潔度

5. Use a grinder to polish the surface to ensure a smooth finish

　　6、完成后進行質量檢查，確保質量符合要求。

6. After completion, conduct a quality inspection to ensure that the quality meets the requirements.

以上是關于 安徽不銹鋼包口 的介紹，若想了解相關知識可請點擊：http://www.k2f3.com 我們將會全心全意為您提供滿分服務，歡迎您的來電！

The above is an introduction to Anhui stainless steel cladding. If you want to learn more about related knowledge, please click: http://www.k2f3.com We will wholeheartedly provide you with full score service. Welcome to call us!